Weighing loads systems |
Adjustable support - SRP
In hot-dip galvanized steel after machining (CEI 7.6) (ZF).
Hole Ø 11 mm. Thickness 2,5 mm.
The 15° angle between two consecutive holes makes it possible to obtain a 15°
- 30° - 45° - 60° slope.
For mounting on sloping ceilings, walls and floors, the ceiling of tunnels and
trenches, using PSP - PRP “U” sections.
|
 |
Hinged support - SCP
In hot-dip galvanized steel after machining (CEI 7.6) (ZF).
In hot-dip galvanized steel and painted blue colour (VB) or gray RAL 7035 (VG).
Slots 13 x 22 mm. Holes Ø 11 mm. Tickness 2,5 mm.
For hangings at falling structures, with PSP - PRP - PSM - PSL “U” sections or
SST - STT - STS supports with TZ pipe.
 download the pdf products file
|
 |
Ceiling support - SSP
In hot-dip galvanized steel after machining (CEI 7.6) (ZF).
Plate of thickness 4 mm. Foot thickness 3 mm.
For PSP - PRP.
|
 |
Ceiling support - SDP
In hot-dip galvanized steel after machining (CEI 7.6) (ZF).
Plate of thickness 4 mm. Foot thickness 3 mm.
Hole Ø 11 mm. For PSP - PRP “U” sections.
download the pdf products file
|
 |
“U” section - PSP
In hot galvanized steel after machining (CEI 7.6) (ZF).
Lenght 3 m. Thickness 3 mm.
Slots 11 x 17 mm with 35 mm center to center.
Suitable for MP brackets and single, double, inclined suspensions, with SSP -
SDP - SCP - SRP ceiling support; as reinforcement arm using SCP supports.
|
 |
Reinforced“U” section - PRP
In hot galvanized steel after machining (CEI 7.6) (ZF).
Lenght 3 m. Thickness 2,5 mm. Slots 11 x 17 mm with 35 mm center to center.
Suitable for MP brackets and single, double, inclined suspensions, with SSP -
SDP - SCP - SRP ceiling support; as reinforcement arm using SCP supports.
Use also PAP clamps to fasten MP brackets to the “U” section.
download the pdf products file
|
 |
Joint for “U” sections - GPP
In hot galvanized steel after machining (CEI 7.6) (ZF).
Holes Ø 11 mm.
To joint/extend PSP and PRP “U” sections.
|
 |
Spacer for “U” sections - DPP
In hot-dip galvanized steel after machining (CEI 7.6) (ZF).
Holes Ø 11 mm.
Siutable for double suspensions, with PSP - PRP “U” sections
and SDP ceiling support.
download the pdf products file
|
 |
Bracket - MP
In hot galvanized steel after machining (CEI 7.6) (ZF).
For wall mounting or on PSP - PRP - PRL - PRM.
Slots 7 x 20 mm on supporting suface.
Mounting plate with hole Ø 11 mm and slot 11 x 17 mm;
the B 110 and B 160 brackets only with one slot 9 x 16 mm on the center.
download the pdf product file
|
|
